This article has been rated as Low-importance on the project's importance scale. Computing Wikipedia:WikiProject Computing Template:WikiProject Computing Computing articles If you would like to participate, please visit the project page, where you can join the discussion and see a list of open tasks. This article is within the scope of WikiProject Computing, a collaborative effort to improve the coverage of computers, computing, and information technology on Wikipedia. This article has been rated as High-importance on the project's importance scale. This article has been rated as B-Class on the project's quality scale. Leave messages at the project talk page Electronics Wikipedia:WikiProject Electronics Template:WikiProject Electronics electronic articles If you would like to participate, you can choose to edit the article attached to this page, or visit the project page, where you can join the project and see a list of open tasks. Take the back off the player once again and flip the battery around and the e200 device should work properly.This article is part of WikiProject Electronics, an attempt to provide a standard approach to writing articles about electronics on Wikipedia. NOTE: If the device goes directly to a black screen after unplugging it, then the battery has been replaced incorrectly. Once the player has connected to the computer and is ready to be used or says "Connected", unplug the device.
Replace the lid to the back of the player and then plug the player into the computer using the Sansa cable.Ħ. Lightly push the lined up battery up against the contacts of the player until the bottom end of the battery can be pushed into place.ĥ.
Be sure these contacts match up with the three gold contacts on the back of the player.Ĥ. NOTE: When replacing the e200 battery be sure that the contacts on the battery line up with the contacts on the player.ģ. The battery has three gold contacts on one end of the battery, which is near the words SanDisk Sansa.
It will not take a lot of force to remove. 1. Remove the back on the e200 by removing the 4 screws.Ģ. Lift off the back by using a finger nail or a small flat head screw driver.
0 kommentar(er)
